Rotary engine stand adapter bolt/thread size

Reply Subscribe

Thread Tools

Search this Thread

07-30-21, 10:21 PM

mkd

Pretending it's 2001

Thread Starter

iTrader: (8)

Join Date: Sep 2019

Location: Santa Cruz, CA

Posts: 573

Likes: 133

Received 63 Likes on 40 Posts

Rotary engine stand adapter bolt/thread size

I'm about to remove my motor and strip it down for a rebuild. I have a "rotary engine stand adapter" but want to know what diameter & pitch bolts go into the short block to hold it.

Reply Like

07-31-21, 10:28 AM

cr-rex

half ass 2 or whole ass 1

iTrader: (114)

Join Date: Nov 2011

Location: okinawa to tampa

Posts: 3,425

Likes: 89

Received 480 Likes on 350 Posts

It mounts to where the ac/ps bracket would be. Pull those bolts out and match it up

Reply Like

07-31-21, 10:54 AM

DaleClark

RX-7 Bad Ass

iTrader: (55)

Join Date: Jan 2002

Location: Pensacola, FL

Posts: 15,399

Likes: 1,903

Received 2,438 Likes on 1,509 Posts

There's also a stud that you use as well. I think the stud is the same as a lug nut - I actually use a lug nut

.

Should be 3 total fasteners that you need, 2 bolts and 1 nut. As CR-Rex said, use the bolts that normally go there or dig around in the bucket of spares and find some that work.

Dale