I just did the simplified sequential when i swapped in a motor. I used resistors but i'm getting codes 30, 33, 38, and 39. Has anyone else had this problem? I'm going to just plug in the solenoids and hopefully that will take care of it. Btw this is with the stock '94 ecu

 

What size resistors did you use?

 

330 ohm 1/2 watt

 

Yep, that should do it. Are you sure the resistor lines are really making connection inside the female connectors?

I made the 'U' shape with the resistor, then inserted it to see how far down it would go... Next, trimmed the legs to make it seat all the way down and wrapped it with some electrical tape so it wouldn't fall out.

 

Mahjik, I put the resistors in close to the way you described only difference i didn't cut them.

 

Sounds like the resistor isn't making contact on both side (or it's damaged).