replacing shocks and spring ?
#1
Full Member
Thread Starter
Join Date: Feb 2001
Location: woodstock,Ga
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
replacing shocks and spring ?
For those who went either eibach and koni or eibach and bilstein, did you use or replace the bottom cushion piece.
With my eibach and bilstein combo I just let the botton of the spring sit directly on the lower spring rest without the foam or rubber cushion. Is this going to cause any problems?
Any quick responses will be appreciated.
Thanks...Scott
With my eibach and bilstein combo I just let the botton of the spring sit directly on the lower spring rest without the foam or rubber cushion. Is this going to cause any problems?
Any quick responses will be appreciated.
Thanks...Scott
#2
the top in the front is pretty important. it is amazing how thick a new one looks if yours is old and squished. as for the bottom, it may squeek and the strut and spring will rub the paint off eachother and it masy rust. the bottom is like 10$
#3
Full Member
Thread Starter
Join Date: Feb 2001
Location: woodstock,Ga
Posts: 172
Likes: 0
Received 0 Likes
on
0 Posts
well i already had 3 done without them so i decided to do the fourth the same.
I was running out of time. Maybe it squeaks maybe it won't.
Thanks for the advice.
Scott
I was running out of time. Maybe it squeaks maybe it won't.
Thanks for the advice.
Scott
Thread
Thread Starter
Forum
Replies
Last Post
NCross
2nd Generation Specific (1986-1992)
9
09-03-15 03:42 PM
82streetracer
1st Generation Specific (1979-1985)
7
08-23-15 09:28 AM