repairing the injector harness
#1
repairing the injector harness
Ok , so I have a question about repairing a broken injector wire , the wire by the connector seems to of broken ,
I was going to solder an extension to make it not as tense and give it some slack that it doesnt have now , but I was told I should NOT solder injector wires that I should use crimps instead because solder causes resistance ? or intereference ?
is there any truth to this ?
I was going to solder an extension to make it not as tense and give it some slack that it doesnt have now , but I was told I should NOT solder injector wires that I should use crimps instead because solder causes resistance ? or intereference ?
is there any truth to this ?
#4
Eats, Sleeps, Dreams Rotary
iTrader: (52)
Ok , so I have a question about repairing a broken injector wire , the wire by the connector seems to of broken ,
I was going to solder an extension to make it not as tense and give it some slack that it doesnt have now , but I was told I should NOT solder injector wires that I should use crimps instead because solder causes resistance ? or intereference ?
is there any truth to this ?
I was going to solder an extension to make it not as tense and give it some slack that it doesnt have now , but I was told I should NOT solder injector wires that I should use crimps instead because solder causes resistance ? or intereference ?
is there any truth to this ?
If your harness is getting that brittle, it may be time to bite the bullet and replace with a new one, or Rywire's single harness depending on your mods.
Thread
Thread Starter
Forum
Replies
Last Post