I am having a problem removing the CD Player in my FD. I tryed using the DIN tool with no sucess. Does anyone any ideas?

 

Did a quick search and this is what I found. You can also search the site.

https://www.rx7club.com/interior-ext...emoval-105800/

https://www.rx7club.com/interior-ext...ummies-404821/

 

The Culprit is likely that rubber bumper on the rear -- it is snug into a metal clamp type hole. You just have to muscle it out. The Din removal tool only releases the side spring clips. I remember getting behind it with a long flathead from the bottom and pushing it free.

 

Mine was pretty tough as well due to what the gentleman above was saying. I managed to wedge the tools at an upward angle and keep steady pressure on it until it popped. Yanking doesn't work.

 

I found it easier to use a coat hanger than a din tool. I used a small 1' section and stuck both ends in the release holes, this gave me a good handle to yank on.

 

Yep, just did this. I had to remove the entire trim plate (ac controls etc) to remove it. Also had to pull the main gauge console out a bit to remove the ac trim plate