i have just put my motor back into my car after replaceing seals and i have a problem if you turn the key i have spark but when its in the running postion i have no spark car will not start

also could this also have something to do with fuel/injectors

i have a Haltech and msd ingiton any ideas on what this can be could it be a bad relay

just trying to find out if any has had the same problem

this is a single turbo setup and i have some wires from the orginal wiring harness that are not being used

 

check the ignition/crank trigger

 

make sure the plugs for crank angle sensors are in the right spots. I can't remember If
its gray or white on top.

Also check all grounds going to the haltech.

JP

 

just an update i have spark for 2 rotations of the motor when you crank it and then no spark you have to turn the key complety off and the back on agian to get spark