recommendations for cutting front bumper reinforcement
#1
Rotary Enthusiast
Thread Starter
Join Date: Nov 2004
Location: las vegas
Posts: 1,017
Likes: 0
Received 0 Likes
on
0 Posts
recommendations for cutting front bumper reinforcement
i wanted to know what is the general forums recommendation when cutting the front bumper reinforcement for installing a FMIC?
#2
I cut about 5 3-inch holes in the reinforcement for flow with a hole saw....its not that hard to cut, just don't breathe in the vapors! An air-powered cutting wheel will most likely do the trick.
Thread
Thread Starter
Forum
Replies
Last Post