Hey guys, its been a while since I drove my 7 and right now I'm getting a new engine from Malloy's installed. While I'm at it I was wondering if you guys had any recommandations for me. So far I got the Koyo Radiator, Silicone Hoses (from HoseTech), Duel Apexi Intakes, and Apexi Turbo Timer. Anything else I should be doing or getting?

I already have Boost and Water Temp gauges installed as well as a cat system.

 

You should get a Downpipe and get rid of the restrictive Pre-cat. You'll really notice the hp increase. Also, get a Cat-back exhaust(or is that the cat system that you mentioned?) After thos two mods you'll be needing an ECU. You can pick up a used M2 Stage III ECU fro $400 from tgriesel on the forum.

 

Aluminum AST, new coolant hoses, downpipe, and do the fan mod.

 

Tom specifically mentions that the ECU is for a '94 - '95 California car sans EGR valve. Would that work with a Federal '93?

 

Whoops, my bad. It probably won't work properly on your car.

 

Cool thanks guys I'll keep those mods in mind, down pipe, Aluminum AST, Coolant Hoses, and fan mod.

 

Have your injectors cleaned and flow balanced by RC Engineering: http://www.rceng.com/service.htm

 

how bout a high flow cat. o yeah and an efini y-pipe

 

Uh, no. Not unless you're running aftermarket fuel management with them.

 

my 2 cents...

DP, CB, Fan Mod., Al AST are all great choices. If you're concerned about overheating some Water Wetter wouldn't hurt and would be a super cheap "mod".

DP would be choice #1 as it's a performance and a reliability mod.

David