RB dual tip install question
#1
Rotary Enthusiast
Thread Starter
iTrader: (4)
Join Date: Sep 2003
Location: Yutan, Nebraska
Posts: 982
Likes: 0
Received 0 Likes
on
0 Posts
RB dual tip install question
This exhaust is very straightforward, however, since it has been a while since I had a factory exhaust (had an HKS carbon titanium before this) I can't remember how this worked...anyways, on the muffler, looking at the muffler from the rear, on the right side, there is a bracket on the RB with two bolts in it, one on top of the other...I assume there is a bracket on the car that connected to this bracket, but I don't see that I have it, and I know I didn't have it on the HKS...I need to post a pic, and will ASAP
Trev
Trev
#2
Rotary Enthusiast
iTrader: (2)
when the stock exhaust was on your car the was a bracket on the right side that had two holes in it where the exhaust bolted to. when you install the HKS one you remove this bracket and put the exhaust directly into the rubber hanger. to install the racing beat one your going to need to get this bracket. Ray Crowe would be a good place to get it from or look in the classifieds, im sure someone has got one laying around.
#5
Rotary Enthusiast
Thread Starter
iTrader: (4)
Join Date: Sep 2003
Location: Yutan, Nebraska
Posts: 982
Likes: 0
Received 0 Likes
on
0 Posts
I liked the look of it awhile ago, but I decided I wanted a more stock look, but with performance still, so I went with the RB...I also wanted a more quiet sound.
Thread
Thread Starter
Forum
Replies
Last Post