Raising FD door procedure?
#1
Full Member
Thread Starter
Join Date: Sep 2006
Location: NJ
Posts: 110
Likes: 0
Received 0 Likes
on
0 Posts
Raising FD door procedure?
I've done my searching and haven't been able to find a DIY procedure on how to align a FD door? My driver side door was installed about 1/4" too low which causes the inside panel to hit the rocker panel.
Does anyone here have any pointers on how to raise the door? If I take it to a body shop, any feel on how big a job this might be?
TIA for your help!
Steve
Does anyone here have any pointers on how to raise the door? If I take it to a body shop, any feel on how big a job this might be?
TIA for your help!
Steve
#3
Full Member
Thread Starter
Join Date: Sep 2006
Location: NJ
Posts: 110
Likes: 0
Received 0 Likes
on
0 Posts
Have you checked either the Collision Repair or Body manual?
http://www.wrex-racing.com/web/fd/info.htm#Docs
http://www.wrex-racing.com/web/fd/info.htm#Docs
1 - Do you need to remove the fender to get to the hinge?
2 - How tough is it to position the door? Any tricks / tips?
3 - Roughly long should it take a body shop to do?
Thread
Thread Starter
Forum
Replies
Last Post
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM