Hey looking at the rear lower control “I”” arms, and mine have a curve to them, and I am thinking that they are maybe/probably not supposed to have curve on them,but be strait, i.e. all bushings centerlines should be in a single plane?

Its hard to tell but from this picture, but they look very strait, does anyone know or have any strait on pictures of good, or preferably NEW set of arms to make a comparison?

Assuming they are not supposed to have a bend to them, is it practical to think they could be put on the press and pushed back?

Or is there a nice set out there somewhere with my name on them?


If you are not familiar with the particular link, it is the furthest link to the right, and the second one in from the furthest to the left.

TIA

 

Those pieces are not supposed to have a bend in them. I checked my extra pair I have out in my shop.