Question: Where does the connector from the OMP attach?
#1
Full Member
Thread Starter
Join Date: Jun 2002
Location: Northern Indiana
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Question: Where does the connector from the OMP attach?
Hello All,
I'm putting the finishing touches on my motor installation and I cannot seem to find where the connector from the OMP connects. I've looked through the shop manual to no avail. Could someone please help me out? It would be appreciated.
Regards,
GAS
I'm putting the finishing touches on my motor installation and I cannot seem to find where the connector from the OMP connects. I've looked through the shop manual to no avail. Could someone please help me out? It would be appreciated.
Regards,
GAS
#2
Rotary Freak
If I remember the wire goes up with the clear oil lines and plugs in near the black tank to the left of the power stearing pump The harness plug is attached to the part that you pull the motor with. I think with out looking. hope this helps
#3
Full Member
Thread Starter
Join Date: Jun 2002
Location: Northern Indiana
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
I still can't find it...
I've looked on the driver's side and still cannot find the connector on the main harness. It is quite a large connector, so it should be easily visible. Could you give me a little more detail as to where it is, perhaps it is hidden behind something else. I appreciate your help.
Thanks,
GAS
Thanks,
GAS
Thread
Thread Starter
Forum
Replies
Last Post
1993fd3sracer1
3rd Generation Specific (1993-2002)
3
09-15-15 10:38 PM