Question about boost creep with midpipe.
10-26-01, 09:20 PM
#1
Question about boost creep with midpipe.
Well I just bought a ATR Stainless Midpipe and Downpipe. I am in on the group buy for the PFC and I already have a Greddy SP Catback. The question is simple. Am I going to run into any problems with boost creep or spikes with the midpipe? I will be buying the M2 Medium intercooler soon but not before I get the PFC and install the exhaust. If I set the boost at 10-12psi what can i expect? Do I need to look forward to the wastegate needing some porting? What about restrictor pills? Any of you guys sort this out yet? Looking for answers from experience so I can take the correct steps if need be. Will probably trailer the car down to KD Rotary this winter and get a few odds and ends taken care of.
10-26-01, 11:17 PM
#2
Passenger
Posts: n/a
I just run the Dawe's controller on the wastegate actuator line and the Home Depot valve on the precontrol line....works great, no spike....I just dial the boost controller a little conservative to account for about 1/2 psi boost creep, which you will get at WFO, esp in 4th
whole alot cheaper than porting the wastegate...esp in this economy
whole alot cheaper than porting the wastegate...esp in this economy
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
