Will the profec B fit in the single DIN panel that blitz makes. The one that holds to 1/4 din controllers and a gauge?

 

Don't know for sure but I bet the Blitz FATT will fit in there, which shouldn't be to much smaller and you could always trim it if needed. I think it is for two 43mm gauges or 1 52mm, you should have plenty of room to cut.

 

The blitz panal already has 2 slots for 1/4 DIN controllers + a hole for a 43mm guage. All the blitz controllers are 1/4 DIN, except for the SBC ID, so I know all the blitz ones will fit in. I was just wondering if the profec B is also a 1/4 DIN size that will fit in the panel.

 

I've been wondering the same thing for some time. The greddy electronices are slightly bigger thant the blitz 1/4 din electronics. I have a 52 mm gauge and a greddy turbo timer, and I'm debating on the profec b (if it fits, for a clean instal) or the the blitz SBC-ID if it doesn't. I've looked it up on a few web pages and the greddy electronics didn't seem to fit very well. Why can't they make one? I may go and try in anyway. I'll post pictures and a write up if it comes out good. Some one should make one for the single din and sell them.
Good luck, let me know what you find.