Profec B Spec II: Need help w/settings
#1
Senior Member
Thread Starter
Join Date: May 2002
Location: St. Pete, Fl
Posts: 373
Likes: 0
Received 0 Likes
on
0 Posts
Profec B Spec II: Need help w/settings
I need some imput from fellow Spec II users as to what my settings should be.
For mods I have: CB/DP/Intake.
So far I have tried:
Gain: 0-10% seem to regulate spiking a bit... but I cannot find a definite setting
Set Gain: 90!?! I have really no clue what this does or where it should be set the manual says somewhere near your boost goal but not too close.
Boost: 25-27% depends on how hot or cold it is
Ok the problem is I cannot get it to hold at a good level it is always fluctuating anyone got any reccomendations.
and at transition it goes from about to about 8psi then drops to 6psi for a sec and wam the secondary comes online.
Anyone help with some settings?
Mitch
For mods I have: CB/DP/Intake.
So far I have tried:
Gain: 0-10% seem to regulate spiking a bit... but I cannot find a definite setting
Set Gain: 90!?! I have really no clue what this does or where it should be set the manual says somewhere near your boost goal but not too close.
Boost: 25-27% depends on how hot or cold it is
Ok the problem is I cannot get it to hold at a good level it is always fluctuating anyone got any reccomendations.
and at transition it goes from about to about 8psi then drops to 6psi for a sec and wam the secondary comes online.
Anyone help with some settings?
Mitch
Thread
Thread Starter
Forum
Replies
Last Post
edgars95rx7
Link Vi-PEC
0
10-01-15 01:59 PM
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM