RX7Club.com - Mazda RX7 Forum

3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:
Full Detail Automotive

Primary injectors question

Thread Tools
 
Search this Thread
 
Old 11-21-05, 07:52 PM
  #1  
Constant threat

Thread Starter
 
bajaman's Avatar
 
Join Date: Jul 2001
Location: near Wichita, Kansas
Posts: 4,952
Received 35 Likes on 31 Posts
Primary injectors question
Okay, I just want to be sure I am not a dumbass, but I need to know:
  • Can or do you remove the injectors from the rail to send them off to be flow tested?
  • The rail body is indeed supposed to locate/seal against 'O' rings in the block at the place shown in the picture?
bajaman is offline  
Reply Like
Old 11-21-05, 08:12 PM
  #2  
DETH TRP

iTrader: (7)
 
4CN Air's Avatar
 
Join Date: Mar 2004
Location: Manhattan Beach, CA
Posts: 2,544
Likes: 0
Received 0 Likes on 0 Posts
they rest on "insulators", they're wider than o-rings. You remove the injectors from the top.
4CN Air is offline  
Reply Like
Old 11-21-05, 10:38 PM
  #3  
7th heaven

 
Bad_Karma7's Avatar
 
Join Date: Jul 2004
Location: Washington
Posts: 607
Likes: 0
Received 1 Like on 1 Post
You're right...have fun...spray some WD-40 in there, might help you get them out easier. I just sent mine to WitchHunter for cleaning.
Bad_Karma7 is offline  
Reply Like
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Installed UIM gasket, now my engine won't run
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Adaptronic FD RX7 Adaptronic PnP ECU Tuning Progression – PT 6266 Single
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
Back to Subforum
3rd Generation Specific (1993-2002)
View Next Unread
A/F ratio question




Advanced Search
Quick Reply: Primary injectors question


Reply Closed Thread Share

All times are GMT -5. The time now is 10:42 AM.