Primary Injectors Grommets, needed?
#1
Full Member
Thread Starter
Primary Injectors Grommets, needed?
Hello,
my car came from the engine builder and I found these 2 Injectors grommets (parts number 13-257) are stil in the Atkins master rebuild kit package.
So I put the rail out and inserted these 2 gromets in the holes on top of the diffusors. but now the engine runs really bad and stalls.
The car is a RX7 Jspec S7 from 96. Are these grommets needed or should i remove them?
This part: https://www.atkinsrotary.com/store/9...1-13-257A.html
best regards
Bastian
my car came from the engine builder and I found these 2 Injectors grommets (parts number 13-257) are stil in the Atkins master rebuild kit package.
So I put the rail out and inserted these 2 gromets in the holes on top of the diffusors. but now the engine runs really bad and stalls.
The car is a RX7 Jspec S7 from 96. Are these grommets needed or should i remove them?
This part: https://www.atkinsrotary.com/store/9...1-13-257A.html
best regards
Bastian
Last edited by Slash200; 07-27-17 at 11:49 PM.
#2
Senior Member
iTrader: (2)
Hello,
my car came from the engine builder and I found these 2 Injectors grommets (parts number 13-257) are stil in the Atkins master rebuild kit package.
So I put the rail out and inserted these 2 gromets in the holes on top of the diffusors. but now the engine runs really bad and stalls.
The car is a RX7 Jspec S7 from 96. Are these grommets needed or should i remove them?
This part: https://www.atkinsrotary.com/store/9...1-13-257A.html
best regards
Bastian
my car came from the engine builder and I found these 2 Injectors grommets (parts number 13-257) are stil in the Atkins master rebuild kit package.
So I put the rail out and inserted these 2 gromets in the holes on top of the diffusors. but now the engine runs really bad and stalls.
The car is a RX7 Jspec S7 from 96. Are these grommets needed or should i remove them?
This part: https://www.atkinsrotary.com/store/9...1-13-257A.html
best regards
Bastian
With the stock fuel rails, yes you need the grommets
#4
My girl
iTrader: (3)
I had to see the link to see that yes that would be needed. Although I have heard two sides about the actual injector diffusers that sit at the bottom that tend to break alot. I pulled my block and those broke when I touched them and seized the motor although it needed to be pulled apart anyway. To think that could happen when in the car would be horrible though.