So i picked up the power fc boost control kit. It looks like the solenoid is setup for the twin system with internal wastegate. There are 3 ports on the boost solenoid. There is NO, NC, and COM. The barb fittings were in no and com. It looks like for the single setup with an external wastegate it should be in nc and com. There is a small brass plug with a very small hole in it. Should i put that into the now vacant no port? It looks like i'm actually supposed to use both the top and bottom fittings for my wastegate diaphragm with this setup. Does anyone have any experience with this thing and a single turbo? I just want to make sure that i am hooking this thing up right. Thanks!

--Hank

 

pics?

 

this is the same solenoid that is used in the Greddy Profec boost controllers and the AVC-R, so you can read their instructions and they will explain how to configure it.

 

COM - always goes to your actuator whether it be external or internal style
NC- pressure source if you have external actuator (single turbo setup)
NO- pressure source if you have internal actuator

This goes for the apexi relay and the greddy relay