3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

possible problem

Thread Tools
 
Search this Thread
 
Old Jun 17, 2007 | 03:08 PM
  #1  
bbade's Avatar
Thread Starter
rx7 addict
Tenured Member: 20 Years
iTrader: (6)
 
Joined: Mar 2006
Posts: 212
Likes: 0
From: Greenville, SC
possible problem

I took my car out for a quick cruise today everything seemed fine, water temps were between 85-91 degrees even though it was quite hot out. I was on my way home about a mile from my house and while boosting there was a loud woosh of air...like the bov just much louder. I had this problem once before and it was because one of the intercooler pipes popped off; however, I checked the pipe and after looking over the engine bay everything seems in order. I did notice that there was some colorless/odorless smoke coming out of the right side of the engine bay, not a lot, but it's something I havn't noticed before. Granted I don't usually check my engine bay over everytime I park the car.

Any ideas as to what the issue may be or if there is an issue. I might take it out later today and see if I can hear it again. Thanks for your help.
Reply
Old Jun 18, 2007 | 06:15 AM
  #2  
CantGoStraight's Avatar
What's your point ?
Tenured Member 10 Years
 
Joined: Feb 2001
Posts: 3,573
Likes: 0
From: Gainesville, Fla.
Sounds like a split coupler, even if they don't pop off they can still rupture.
Reply
Old Jun 18, 2007 | 04:03 PM
  #3  
bbade's Avatar
Thread Starter
rx7 addict
Tenured Member: 20 Years
iTrader: (6)
 
Joined: Mar 2006
Posts: 212
Likes: 0
From: Greenville, SC
I havn't been able to take the car out and replicate the problem as of yet; however, you think one of the couplers for the intercooler pipes split?
Reply
Old Jun 18, 2007 | 04:21 PM
  #4  
VTECthis's Avatar
Apexsealistically Chalngd
Tenured Member 20 Years
iTrader: (4)
 
Joined: Feb 2001
Posts: 476
Likes: 6
From: Maryland
car still make boost? could have been either a coupler or a bunch of vacuum lines...also, which side of the engine bay is the right side? passenger or driver?
Reply
Old Jun 23, 2007 | 06:40 PM
  #5  
bbade's Avatar
Thread Starter
rx7 addict
Tenured Member: 20 Years
iTrader: (6)
 
Joined: Mar 2006
Posts: 212
Likes: 0
From: Greenville, SC
Hey guys I found the problem, the pipe from the intercooler to the turbo popped off right at the y pipe so it wasn't visible until i started pulling things apart. thanks for your help.

I'm guessing the rubber couplings are getting old, where would one buy the nice polished pipes and couplings?
Reply
Old Jun 23, 2007 | 07:43 PM
  #6  
scorpnaz7's Avatar
Car n' Shop
Tenured Member 15 Years
iTrader: (2)
 
Joined: Jun 2006
Posts: 147
Likes: 0
From: San Diego
get the efini y pipe
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
WyomingTII
2nd Generation Specific (1986-1992)
12
Sep 28, 2015 10:32 AM
lnlreaper
2nd Generation Specific (1986-1992)
2
Sep 27, 2015 09:59 AM
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM




All times are GMT -5. The time now is 04:42 AM.