Plug Analysis
Thread Starter
Rotary Freak
Joined: Jul 2001
Posts: 1,817
Likes: 16
From: South Carolina
Plug Analysis
I just finished an EGR job. During that job, I decided to change the plugs.
The plug job was prompted by a large hesitation I was getting at around 3500 RPM at hight speed WOT (~80 MPH.)
These pugs have only around 15K miles on them. They are not wet and the seem to be buring fairly evenly.
Does anyone have any comment on thier look. The outter plugs are the leading and the inner are the trailing.
The plug job was prompted by a large hesitation I was getting at around 3500 RPM at hight speed WOT (~80 MPH.)
These pugs have only around 15K miles on them. They are not wet and the seem to be buring fairly evenly.
Does anyone have any comment on thier look. The outter plugs are the leading and the inner are the trailing.
Senior Member
Joined: Oct 2002
Posts: 394
Likes: 1
From: Bartlesville, OK.
Found this site a while back. They have an interesting on-going test of different plugs.
www.silverbulletrx7.com/plugs.html
www.silverbulletrx7.com/plugs.html
Thread
Thread Starter
Forum
Replies
Last Post
HalifaxFD
Canadian Forum
126
May 9, 2016 07:06 PM