I am guessing this is the o2 sensor? Am I right?


Don't know what these two are...



I believe two of these are pre-control and one is the wastegate. I tried identifying them through the paper that says wire colors, but to me... it looks like two of them are exactly the same. I want to keep the wastegate one, which wire colors are the wastegate?





Also, at the ECU end of the harness.. how is everyone getting un needed wires out of the large connector? At this point I've just cut them all at different lengths and heat shrink ed the ends, but I would like to remove them completly if I can.

 

Anyone...

I`m trying to finish this thing up right now... any input would be appreciated.

 

Looks To me , Pic 1 o2 , pic 2 low coolant level , pic 3 air pump. Not sure on the outhers without checking my spare loom. Hope it helps, Rix

 

So that long one is the airpump?

thanks!

I will try to read the colors a bit better on the 3 that look the same but they are very hard to see.

 

It is, Checked on mine as its just hanging doing nothing. Good luck on the outhers. Rix

 

 

is it an automatic harness or manual?

 

wastegate should be blue/white and black/white
precontrol should be blue/yellow and black/white
purge should be green/yellow and black/white


all three have the same sort of plug.

 

I think I figured it out... I had both those pictures. One of the harnesses were blue and white the other was blue and tan... so it was hard to tell the difference.

I`m all done it now, just waiting on two new clips and some proper heat resistant tape.

 

the wastegate clip should have a white dot on it.