Ok so i just bought a fd shell and put a jdm 13b in it, there are some wires that i dont know where they go and i need help from you guys, On the body harness there are three wires located by the oil pressure sending unit the first one is Black with red strip, the second is brown with blue strip, the third is yellow with red strip.
On the engine harness there is a yellow wire with a white or silver strip and is located right before the engine harness enters the engine. The last thing is the blue connector that connects to the piece inside the car from the engine harness, both pieces are different sizes and dont fit < what the hell are these wires and what do they do, i live in a condominium and its against the rules to work on my car in the garage so i need it done by tomarow, the car wont start so are these any reason for the car not starting? i also have done a non-sequential conversion done but didnt put resistors in the rats nest wires so will that not make the car start?

Please Help

 

Are you trying to use a jdm wiring harness in a usdm car? Im pretty sure that wont work but could be mistaken, possibly some years can be interchanged but I dont think so.

The resistors will not prevent the car from starting but will cause the car to buck and back fire when you get out of vacuum.

 

The Jdm engine i got with it had the wiring harness cut so i put a 95' one in from a usdm car, that harness came with the shell that i bought so it could be auto or manual im not sure, he never had it connected to the car. would the blue connector cause it to not start though?

 

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/ecu-connections-786708/