PFC+Emissions question
#1
Senior Member
Thread Starter
Join Date: Apr 2002
Location: Boston, MA
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
PFC+Emissions question
I put in a PFC recently and set the fuel map to extra rich in most places since I haven't had a chance to properly tune it yet. I have the basic bolt-ons (air intake, DP, high-flow cat, CB, SMIC) plus a denso fuel pump. Do you think it would be a bad idea to pop in my stock ECU for the emissions test? Or is there some other "safe" map I could load my PFC with just for the test?
#2
Lives on the Forum
Join Date: Dec 2001
Location: San Lorenzo, California
Posts: 14,716
Likes: 0
Received 8 Likes
on
8 Posts
Well for one thing, you didn't need to set the PFC "super rich" with those mods...running rich isn't good for the motor either.
You can easily run those mods with a stock ecu (at 10 psi or less), and certainly for a smog test (no boosting).
You can easily run those mods with a stock ecu (at 10 psi or less), and certainly for a smog test (no boosting).
#5
Banned. I got OWNED!!!
Join Date: Jul 2004
Location: next to the polishing wheel!!!
Posts: 1,179
Likes: 0
Received 1 Like
on
1 Post
With my PFC in place , I put the main cat on ,lean out the gas at idle and retard the timming on the IGL/T,FI setting screen . This is working with 850cc pri and 1680 cc sec injectors .
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM