Sound like I need to keep my car for a while before putting it to junkyard. If any body need factory interior accessories email me
[/email]jnpham54@aol.com
My it a tan interior

 

just need a throttle body
you have mail

 

Do you have the jack, wheel chalk and the bar for the jack? I could also use the little push pocket that goes underneath the stock cassette player. Send me an email at coanders@vt.edu if you have either of these.

- Cody

 

Is your FD a 93? If so, hows the peeling situation on your center console cover? (its the plastic cover that goes around the shifter, defroster/foglight switch, ashtray, etc.) If it has no peeling yet, I'm interested in that. And if you recall, same with the ABS unit in your previous post. Not necesarilly the lines, just the unit itself. (if it hasn't been damaged of course ) Thank you.

 

This is going to be a little peculiar, but I need the rear sway bar brackets and bushings. I took mine off and put an aftermarket one on but didn't like the feel but I couldn't find the brackets/bushings for my stock one.
How about the bolt that holds the sway bay to the end link on the rear as well. Our local hardware store can't seem to match mine up for some reason.

Tim Benton

 

I need the rear bumber skin and black plastic piece that screws into the bottom of it if its all still intact. I could also use one of the spare buttons from the armrest (ie blank foglight switch) if those are black.

 

Ok, I would need the little black plastic oval cover passanger side from the bottom windshield cover of the windshield wipers. It covers the screw that holds on the cover. If you need a pic of the location, let me know.

 

Passenger side "pistol grip" door handle assembly in black. Email address in right above my sig if you want to contact me about it. Thanks!

 

I AM DESPERATE, I NEED THE INTERIOR DASH IF THERE ISNT ANY DAMAGE, I NEED THE GAUGE CLUSTER HOOD ONLY, I HAVE THE CLUSTER BUT MY HOOD FOR IT IS RUINED AND I NEED A HARNESS THAT PLUGS INTO THE CLUSTER, PLEASE WRITE ME BACK ASAP I NEED THESE PARTS BAD

 

I need the little **** that's used to tune the bass/treble on the radio.

And if you can manage to remove the rearview mirror from the window, I'd like only the part that is glued to the window.

How good of shape are the "covers" for the seat bracket bolts? I may want those as well.

 

check pm's

 

i need to volume **** for the stock, non-bose stereo!

 

I am wondering if you still have the passenger side vanity sun visor with mirror in good condition. I just need the passenger side, not the driver's.

 

If you have a power antenna Ill take it. Did your hood survive? If so Ill take that too. just PM me how much you'll want

 

I could use the driver's side seat if it is in good condition. billmueller@erols.com

 

I need the trunk flip down "visor" thingy, but in black...

 

I need the passenger door interior grab handle assembly.

Mine broke in September when i reached over from the driver seat to close the passenger door.

 

Damn guys... Y dont u say the whole car... The only thing that will be left by the time u guys get done is the shell..