Hello folks!

​​​​​​I'm just wondering how to remove the oil return line from the oil cooler. The one that goes from the cooler to the pedestal.

Removing it from the cooler is no issue, and no worries with the pedestal either.
It's just the "holder" under the AC I'm wondering about. The holder is located right beside the oil feed line to the cooler.

Thanks in advance!

 

I’m a little confused about where exactly you’re wanting to disconnect the lines, but does this help?

 

Thanks for reply! The holder I'm talking about is a bit further back, and holds the hard oil line back to the pedestal. Just under the AC compressor.

 

It's a p clip wedged between the front iron and the ac/ps bracket, you'll need to remove the bolt that goes through the AC bracket to get it out. Depending how tight it is you may need to slacken the others also which would involved loosing the compressor also but this isn't bad to do in the bay.

 

the as/ps bracket has to come off to get the line out in 1 piece. it routes directly under it