willub and company

iTrader: (3)

does anyone know how to remove the oem front turn signal lens with out wrecking it? it is held on by 6 clips. i feel like i'm going to break it when i try prying it with a flat head. does anyone have a suggestion??

junkie81

iTrader: (8)

hey a fellow Mass fd owner. to open your oem turn signals, use a heat gun to warm up the glue or put it in the oven for a minute or two. Sounds dumb, but it works, i did this for the front and back lights.

dave

quicksilver_rx7

If you're talking about the lenses on the front of the front bumper, take the screw out, and on the same corner that the screw hole is located, pull out on that edge of the lens, then pull away, like you are opening a door. It has a retaining clip on the oppostie side that will release as you pull. It feels like it is going to break or stretch something, but it will be okay. Don't ****** it though. As a matter of fact, don't ****** anything on an FD.

Joe