OEM Bra Installation Instructions for FD
#1
Rotorgoblin
Thread Starter
iTrader: (4)
Join Date: May 2001
Location: S FLA
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
OEM Bra Installation Instructions for FD
I just found a second hand bra for my '94 and I'm in need of a copy of the OEM installation instructions. There are apparently two places where the bra attaches to the car via snaps.
In order to take any of the guess work out any modifications I need to do to make the bra fit correctly, I'd appreciate any assistance from those in the know. I understand that Mazda stopped selling these around '97.
Thanx!
In order to take any of the guess work out any modifications I need to do to make the bra fit correctly, I'd appreciate any assistance from those in the know. I understand that Mazda stopped selling these around '97.
Thanx!
#2
2 babies - no back seats
Join Date: Nov 2001
Location: N. Wilm., Delaware?
Posts: 981
Likes: 0
Received 0 Likes
on
0 Posts
Don't have the instructions but you probably need to buy the 2 snaps which attach to the front fenders. They go in place of the inner fender screws. Other pointer is to leave the bra in the sun to warm it up. You have to stretch it a little and it's impossible when it's cold.
#5
2 babies - no back seats
Join Date: Nov 2001
Location: N. Wilm., Delaware?
Posts: 981
Likes: 0
Received 0 Likes
on
0 Posts
I got both of mine from either Home Depot or Lowes. They have a fastener section which has at least 2 sizes of snaps. Best to bring the bra with you (or an old snap) to get the size correct. You also need new flush screws to put them in. Again, I used HD or Lowes and got 2 stainless recessed screws.
Last edited by rotary-tt; 04-27-04 at 05:11 PM.
Thread
Thread Starter
Forum
Replies
Last Post