O2 Bung Install/DIY Wideband Question
#1
Senior Member
Thread Starter
Join Date: May 2002
Location: Frisco, TX
Posts: 281
Likes: 0
Received 0 Likes
on
0 Posts
O2 Bung Install/DIY Wideband Question
I just ordered the Oz Wideband and will be installing the 5-wire NTK sensor soon.
Do most muffler/exhaust shops have the O2 bung itself, or will I need to locate that from a parts supplier?
How much should I expect to have a bung welded on?
Is the O2 bung just an M18 nut that is welded on?
Lastly, for those of you using the Oz-DIY setup, how did you run the sensor cable? I bought the shorter cable; is that enough length to run through the firewall if I mount the sensor on the vertical part of the downpipe?
Thanks.
Do most muffler/exhaust shops have the O2 bung itself, or will I need to locate that from a parts supplier?
How much should I expect to have a bung welded on?
Is the O2 bung just an M18 nut that is welded on?
Lastly, for those of you using the Oz-DIY setup, how did you run the sensor cable? I bought the shorter cable; is that enough length to run through the firewall if I mount the sensor on the vertical part of the downpipe?
Thanks.
#4
Senior Member
Thread Starter
Join Date: May 2002
Location: Frisco, TX
Posts: 281
Likes: 0
Received 0 Likes
on
0 Posts
I just got the diy controller (v1.0) and the shorter cable. It was $178.
I didn't need the display as I have a datalogit I'm using with my PFC.
I still need to pick up a O2 sensor; they run about $140-150.
I didn't need the display as I have a datalogit I'm using with my PFC.
I still need to pick up a O2 sensor; they run about $140-150.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM