RX7Club.com - Mazda RX7 Forum

3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:
Full Detail Automotive

Nonsequential on Pettit BPHF turbos .. only 8psi at 4000?

Thread Tools
 
Search this Thread
 
Old 01-23-09, 03:32 AM
  #1  
wtf rotary wtf

Thread Starter
iTrader: (3)
 
hurleysurf24's Avatar
 
Join Date: Aug 2005
Location: Who knows
Posts: 2,756
Likes: 0
Received 1 Like on 1 Post
Nonsequential on Pettit BPHF turbos .. only 8psi at 4000?
Am i missing something?

I have the pettit chip and im only hitting 8psi at 4000 but then around 5500 am pulling a full 10-11.

I thought it was suppose to be 10psi as soon as it hit around 3500-4000ish?
hurleysurf24 is offline  
Reply Like
Old 01-23-09, 05:31 AM
  #2  
Goodfalla Engine Complete

iTrader: (28)
 
Monkman33's Avatar
 
Join Date: May 2005
Location: Kennewick, Washington
Posts: 3,238
Received 32 Likes on 25 Posts
non sequential...
Monkman33 is offline  
Reply Like
Old 01-23-09, 08:21 AM
  #3  
Senior Member

 
drew32's Avatar
 
Join Date: May 2007
Location: Wilmington, DE
Posts: 285
Likes: 0
Received 2 Likes on 2 Posts
Did you do rich or poormans non seq? I know the poormans isn't as good and usually doesnt build full boost until a bit later.
drew32 is offline  
Reply Like
Old 01-23-09, 11:36 AM
  #4  
wtf rotary wtf

Thread Starter
iTrader: (3)
 
hurleysurf24's Avatar
 
Join Date: Aug 2005
Location: Who knows
Posts: 2,756
Likes: 0
Received 1 Like on 1 Post
rich mans
hurleysurf24 is offline  
Reply Like
Old 01-23-09, 08:29 PM
  #5  
Goodfalla Engine Complete

iTrader: (28)
 
Monkman33's Avatar
 
Join Date: May 2005
Location: Kennewick, Washington
Posts: 3,238
Received 32 Likes on 25 Posts
sounds like your wastegate isn't holding properly then. Check to see if there is play in the shaft, or to see how much tension is holding it closed. Also, check to see if your boost controller is properly hooked up.
Monkman33 is offline  
Reply Like
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Microtech how do you set timing?
stickmantijuana
Microtech
5
08-23-15 11:04 AM
Tags
Back to Subforum
3rd Generation Specific (1993-2002)
View Next Unread
Missing flywheel dowel pins




Advanced Search
Quick Reply: Nonsequential on Pettit BPHF turbos .. only 8psi at 4000?


Reply Closed Thread Share

All times are GMT -5. The time now is 08:34 AM.