Non Sequential and PFC to control boost?
12-02-01, 08:05 AM
#1
Retired RX7 mechanic
Thread Starter
Join Date: Feb 2001
Location: Long Island, NY
Posts: 999
Likes: 0
Received 0 Likes
on
0 Posts
Non Sequential and PFC to control boost?
Why would I need a Boost controller if going Non sequential? I already have a PFC to control boost....Let me know what you think
12-02-01, 08:35 AM
#2
Rotary Freak
iTrader: (15)
just bought my PFC. i was already running nonseq with the avcr controlling. found no use for it to i took it out along with the entire rats nest under the upper intake manifold.
with the PFC running boost control, you should know that spiking is less controller as compared to the AVCr. boost control on the PFC uses the factory solenoid, while the AVCr uses the beefier solenoid provided.
IMHO, if you have enough fuel on your PFC map, a little spiking should be fine.
with the PFC running boost control, you should know that spiking is less controller as compared to the AVCr. boost control on the PFC uses the factory solenoid, while the AVCr uses the beefier solenoid provided.
IMHO, if you have enough fuel on your PFC map, a little spiking should be fine.
12-02-01, 10:39 AM
#3
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,894
Likes: 0
Received 114 Likes
on
66 Posts
To control non-seq boost witht the PFC, turn seq boost control off and use the pre-control solenoid in place of the boost solenoid. Otherwize the procedure is the same.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
