3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

no exhaust

Old Jan 31, 2004 | 01:10 AM
  #1  
Daniel577h's Avatar
Thread Starter
danny rocks
Tenured Member 10 Years
 
Joined: Jun 2002
Posts: 330
Likes: 0
From: bay area, petaluma
no exhaust

I took off my exhaust today but i messed up one of the bolts at the end of the cat. I got the end part off after the cat, and was wondering if it would harm the motor or anything else since i want to go and get the stud removed and replace since i dont have the tools to do it. So would it hurt anything?
Reply
Old Jan 31, 2004 | 01:49 AM
  #2  
austinsFD's Avatar
Ahhhh Motherland!
Tenured Member 05 Years
 
Joined: Nov 2003
Posts: 715
Likes: 0
From: CA: Van Nuys
if the exaust holds pressure with the bolt that got messed up you should be fine and make sure the exaust dosn't wobble or it could damage you entire exaust
Reply
Old Jan 31, 2004 | 02:12 AM
  #3  
racerfoo's Avatar
Senior Member
Tenured Member 10 Years
 
Joined: Jul 2001
Posts: 615
Likes: 1
From: Southwest Missouri
i drove my car to the exhaust shop with open downpipe pretty much, the cat was on but hollow. Loud as a mother freaker...but no harm done.

Just dont get on it, boost might go dangerously high.
Reply
Old Jan 31, 2004 | 05:58 AM
  #4  
mazdaspeed00's Avatar
For Sale
Tenured Member 20 Years
iTrader: (6)
 
Joined: Jul 2001
Posts: 2,133
Likes: 0
From: Irvine
just dont drive your car at WOT keep the boost under 10 psi and you will be ok.
Reply
Old Jan 31, 2004 | 09:35 AM
  #5  
MazdaRx7Racer4Life's Avatar
I AM A THIEF!! READ THE FEEDBACK SECTION!
Tenured Member 05 Years
 
Joined: Aug 2002
Posts: 86
Likes: 0
From: Miami, FL
When I had my fc, it was na, so open exhaust = more power, no boost creep worries, I took everything off right up to the manifold, then I drove it around, the MONSTER V8 guys would wave at me like syaing "sorry dude, too much power for me" I flamed to the floor and everything, it was nice to feel so respected.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Ian_D
New Member RX-7 Technical
6
Sep 6, 2015 10:38 PM
doritoloco
New Member RX-7 Technical
7
Sep 5, 2015 12:41 PM
FührerTüner
General Rotary Tech Support
3
Sep 4, 2015 01:41 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 12:22 PM.