RSL Cpt Mike

i have a 93 FD and its actin up alot. its burning oil, and ive rewired the ignition system (was needed) but the real probleme is that the car will run ok for a while but then randomly run like **** and wont stay running, i have to start it over and over and step on the throttle until it pops out some fire and **** and it will run again for a while. ne ideas advice or whatever ill take it thanx. mike

gafu mazda

you need to list what mode the car has in order to be helped out,at least thats what I always read here when someone is having a problem.Good luck

RSL Cpt Mike

Well i resodered some wires and the main prob is fixed. but i am still burnin oil. its a stock turbo set up non sequential, full exh, street port and PFC. any segguestions on what the cause of the oil burning might b? i know im still gettin used to the REs.

fendamonky

iTrader: (6)

When you say burning oil, do you mean in copious amounts, with tons of smoke and all?? Or do you just mean that every week the oil level is a little lower than the week before??

FD's consume oil naturally as a means of lubricating their seals, so if it's just a little bit missing, at a steady rate, than you're good to go.

As for everything else.. that kinda sucks, whats the compression?

Zhé

iTrader: (2)

and wtf oil are you using?

RSL Cpt Mike

i use non sythetic 10 30. and no its smokin like a hippie. the other stuff i think i fixed i went back and redid my wireing again. hey also where exactly is the PCV located cus i know those like to b replaced often too so im thinkin that might have sumthin to do with all this.