Just need to know which orfice each intake has, does the skinny hose hook up to and which one to cap off, or if it even matters which one it's hook up to. Got the car with it already installed with a HKS bov

 

https://www.rx7club.com/showthread.p...ght=HKS+Intake

 

not sure if this is what you want, but here is mine when I first put it on. The black tape is to secure the nozels in while the seal-all was sealing.

 

Do not remove the intercooler shroud unless you have a new shroud or are making a new one. Without it the IC will be starved for fresh air and will cause higher intake temps. I ran without one for a few days but I drove easy because detonation makes babies cry.

If anything get some aluminum sheet and make a custom IC duct or cap off the intake hole at the top so all the air goes to the IC instead of escaping out of the top. You could also stick the 'cover' of the stock air box back on and clean things up a bit without sacrificing function. I'm thinking of putting mine back on when I get my motor back in just for the sake of looks.

~Kris

 

The one hose that is said to have an air filter is connected to nothing. I did a search on that hose and it was said that it wasn't suppose to connect to anything and vented air. I think it was called the moo tube or mystery hose. So is it in fact suppose to connect to the intake? My original question was about the crv hose and wondering where it connected. Even though I think I have a newer version I think I have it at the right spot. It was originally connected to the higher (longer) intake but the instructions it came with had it connected to the lower (shorter) intake.

 

Go to rotaryextreme's website they have a good pic.. You should ask them how to install it cuz they did a good job putting mine in