3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Need help please!!

Thread Tools
 
Search this Thread
 
Old 11-12-01, 08:41 PM
  #1  
Rotary Enthusiast

Thread Starter
 
sub-zero's Avatar
 
Join Date: Oct 2001
Location: Canada
Posts: 1,020
Likes: 0
Received 0 Likes on 0 Posts
Need help please!!

Guys, I just had an engine rebuild after a melt down due to a rad failure. I upgraded to 3mm seals, Fluidyne rad,intercooler,etc. This cost alot of money to make the car reliable and of course fast. But I was out breaking in the motor and it started to heat all of a sudden, so I turned it off and let the fans run to cool it down. Thermo-stat!
My ? is should the guys that rebuilt it not have put in a new thermo-stat after a severe overheat? I think I did not damage it but it does idle alot worse when it is cold. They said no warranty on a overheat. After all the cash I spent I am pissed off that they would even say that.
What would you say? and it was a RX-7 shop.
Old 11-25-01, 10:13 PM
  #2  
Speed Mach Go Go Go

iTrader: (2)
 
GoRacer's Avatar
 
Join Date: Oct 2001
Location: My 350Z Roadster kicks my RX7's butt
Posts: 4,772
Likes: 0
Received 2 Likes on 2 Posts
Thumbs down Bad race shop

What's up with that? If they test drove it, they should have seen it get hot. Did you go past 3/4 or red line? You should have towed it to the shop.

Unfortunately the top 1/2 of the engine isn't what gets rebuilt. They make it sound like a whole new engine but it the housing and rotors that get worked on.

They should have looked for problems after the install. It might have been overheating that killed your engine. Usually that or too much boost.

Unless you went in the red, I think you are ok but don't drive it...tow it to the shop.




All times are GMT -5. The time now is 12:12 PM.