slopoke03

Sup guys, anybody here have experience mounting an ASP Large IC. Just got one and it doesnt come with instructions or mounting brackets. Pics would help too. THANKS!!!

ilostmypants

make brackets.

jpandes

I have an ASP/M2 Large. You don't need brackets. Just place the Duct, (you have a duct right?), and tighten the IC pipes. You don't need any extra brackets .

Kevin T. Wyum

Agree with jpandes. You shouldn't need to fabricate anything, unless you're trying to keep your AST then there's a lot of different ways to do that. Remove the plastic tabs on the crossover bar and replace the 10mm bolts with flathead machine screws if you can. You might also stick a piece of rubber or velco on just to stop vibration. Once the duct is in place that keeps the IC from moving. The core rests on the cross bar underneath, the rubber seal on the duct in front and the pipes push it against the duct once clamped.

slopoke03

....and nothing is needed to hold the duct in place? Ill try it out this weekend.

rotorbrain

the duct is pretty much wedged in there. . . it isnt going ANYWHERE once installed. the whole setup is built to be able to just "wedge" in there.