I have installed a full MSD Ignition system on my car and have ran into a problem with break up. I am using an MSD DIS 2, an MSD 6AL for the Leading. I have three trigger wires running from the Haltech E6K (Blue= T1, White with Black line = T2, Green = Leading) then from the ignition boxes i run to 3 MSD coils. (2 MSD coils one for each trailing and one dual tower coil for the leading) My problem is for some reason the egt readings are running higher than before and on idle the car feels lazier and and takes longer to start. it would be awsome if i could speak with someone who had done this sort of setup already or that may shed some light on this problem.

Thanks
Rob

 

Are you sure the Haltech can fire the MSD DIS and AL straight without an ignitor?

If so, do you know if they fire off a rising edge or falling edge...if so, is it configured correctly in the ignition set-up?

Does the MSD DIS 2 have a toggle for the two trailing? I'm not familiar with it.