Need Help!
Thread Starter
Full Member
Joined: Jan 2005
Posts: 220
Likes: 0
From: California
Need Help!
does anyone happen to know where these plugs belong? PICTURE 1 is located behind the powersteering pump.. PICTURE 2 is located behind the alternator.
Last edited by JDMEnthusiast; Mar 18, 2006 at 03:30 PM.
Constant threat
Joined: Jul 2001
Posts: 4,968
Likes: 39
From: near Wichita, Kansas
Yup! That is the 02 sensor plug.
Sorry...I didn't see clearly where it was at....you are coming off the large harness right behind the power steering pump....NOT behind the UIM as I first thought.
Hell....I JUST hooked this thing up a couple of weeks ago. It comes from right down the right front side of the engine, it comes from just underneath the oil filler neck. That is all I can see right now....sorry!
Sorry...I didn't see clearly where it was at....you are coming off the large harness right behind the power steering pump....NOT behind the UIM as I first thought.
Hell....I JUST hooked this thing up a couple of weeks ago. It comes from right down the right front side of the engine, it comes from just underneath the oil filler neck. That is all I can see right now....sorry!
Last edited by bajaman; Mar 18, 2006 at 03:21 PM.
Joined: Mar 2001
Posts: 30,783
Likes: 642
From: FL-->NJ/NYC again!
Hmmmm. Air Conditioning compressor perhaps?
Edit: I was basing this on the proximity to the oil dip stick, ie location in engine bay.
if you have the harness out of place, than never mind. it definitely could be the o2 sensor as baja states.
Edit: I was basing this on the proximity to the oil dip stick, ie location in engine bay.
if you have the harness out of place, than never mind. it definitely could be the o2 sensor as baja states.
Joined: Mar 2001
Posts: 30,783
Likes: 642
From: FL-->NJ/NYC again!
Originally Posted by JDMEnthusiast
what about the second picture?
The first on looks power steering, the second a/c. You shouln't be able to mix them up. The 02 sensor is no where near there. BTW, that harness is toast. The looming around the crank angle sensor wires is all broken off and the shielded wire is exposed.