Ok, it wasn't until I was pulling the stock rad out of the car that I discovered it has an integrated auto tranny cooler. (I didn't search because it never crossed my mind.) I knew the car had a tranny cooler off to the side, so this was a surprise.

So, now I have a Koyo ready to go and I also have a long external tranny cooler that I need to figure out where to mount it. Its length is about the same width as a factory radiator.

I have been looking for a good location to no avail. There is very little room up front without deleting parts. I think one possibility would be to mount it to the back side of the fan housing. My thinking is that it would get a fair amount of air on the highway when the tranny is under load and it would also get the benefit when the fans are on. Problem is that my car is in pieces right now and I can't remember if there is any space there at all.

Any suggestions on where this should go?