hey guys, i havent been on this forum in a while as my computer time is limited. . . my computer caught on fire. hehe. anyways, ive been doing a motor swap (nice and slow, ) and i was in the process of pulling the water pump assembly off. i noticed that there are to plugs in the back. im not sure what the sensors are, but i know for a fact that one of the plugs is broken from the wire. i was disconnecting the plugs from their sensors and the lower one (it only has one "prong" to slide into the sensor) snapped right at the plug. . . damnit. what sensor is this? this really sucks. i REALLY dont want to have to buy a new harness. if i could solder it back on i would, but the wire broke off very close to the plug and there isnt much room. anybody have any ideas.

ill try to get some pics, but its unlikely due to my computer problem.

thanks,
paul

 

The single wire is the thermosensor to turn on the fans the other goes to the ECU. the one under the oil filter ( very small ) goes to the gage. Garfinkle has one from a miata ,new if you wont it , the fans will come on sooner. call him

 

I was wondering what happened to you. Do the fan mod and turn ya fans on when you want to

 

the miata fans switch is N350-18-840

mike