With the LC 1 do I only need to hook up the analog to the datalogit box? What about the system ground wire do I simply hook that up along with the heater ground? With the LC1 instruction it says,


(Connect the System Ground to where you will use the analog out signals. If you use the analog out signals as input for an ECU or datalogger, connect the system ground to the ground of the Ecu or datalogger.)


Not really sure at the Datalogit box, (if there is a connection dont know) or at the ECU ground?

 

also for the other analog outputs I would like to use it as a narrowband since the WB02 is in the stock location. At what voltage do I need to adjust inorder to simulate the stock narrowband sensor? I was thinking 0v-1v but not sure.

 

Everything you ever wanted to know:
https://www.rx7club.com/power-fc-forum-47/inovative-wideband-o2-441157/