KSP/Attain solid gyro motor mounts - anyone use them?
#1
Speed Mach Go Go Go
Thread Starter
iTrader: (2)
Join Date: Oct 2001
Location: My 350Z Roadster kicks my RX7's butt
Posts: 4,772
Likes: 0
Received 2 Likes
on
2 Posts
KSP/Attain solid gyro motor mounts - anyone use them?
http://www.ksp-eng.co.jp/ATTAIN/menu5/8.html
Since these allow the engine to move, it should keep the stress off. I am considering these since my eurathane one melted and cracked without a heat shield. Some vibration is ok, even Harley vibration could be a good thing for the passenger but I don't want the plastics rattling.
My other choice is the Delrin becuase of it's innovative boltless design but will it melt to?
Since these allow the engine to move, it should keep the stress off. I am considering these since my eurathane one melted and cracked without a heat shield. Some vibration is ok, even Harley vibration could be a good thing for the passenger but I don't want the plastics rattling.
My other choice is the Delrin becuase of it's innovative boltless design but will it melt to?
This product is very effective vis-a-vis circuit travelling. The half accelerator, such as full opening and engine brake at the time of circuit travelling where engine output changes bewilderingly to left and right largely as for the engine it moves. Stability of shifting improves largely by holding down this and the sense of relief of the driver improves largely. In addition, like the rubber mount because it does not move, it is very effective in the point of the acceleration response immediately after the accelerator turning on. At this corporation using for also drag race, it increases by the fact that the movement of the engine uses this product largely, the judder when departing - to hold down dramatically it can do with the rubber mount but vis-a-vis the high grip tire + large output engine. Installation basically becomes exchange with the normal mount. It is not necessary for large job such as engine removal and re-installation to loosen and/or without necessity, because of spherical bearing structure the engine the case where with such as mission removal and re-installation job it can tilt to remove the mount and the rubber make mount compared to smoothly the engine it is possible to be able to tilt.
#2
Moderator
iTrader: (7)
Originally Posted by GoRacer
http://www.ksp-eng.co.jp/ATTAIN/menu5/8.html
Since these allow the engine to move, it should keep the stress off. I am considering these since my eurathane one melted and cracked without a heat shield.
Since these allow the engine to move, it should keep the stress off. I am considering these since my eurathane one melted and cracked without a heat shield.
Dave