Installing Profec B, do I need these vac lines?
Thread Starter
Full Member
Joined: Apr 2006
Posts: 212
Likes: 1
From: dallas
Installing Profec B, do I need these vac lines?
I just did the full nonsequential mod an bought a profec b spec 2.
Do I need any of the lines highlighted in red? I assume those are only for the wastegate to operate, but if I take those all off and then install the controller I should be fine right?
Just want to besure before I start pulling hoses, the ones on the engine under the UIM were a bitch.
Do I need any of the lines highlighted in red? I assume those are only for the wastegate to operate, but if I take those all off and then install the controller I should be fine right?
Just want to besure before I start pulling hoses, the ones on the engine under the UIM were a bitch.
Rotary Enthusiast
Joined: May 2002
Posts: 1,205
Likes: 0
From: Tallahassee, FL
if you still have the OMP then you need to keep that one that's split to those two oil injectors.
the other one you don't need anymore, and the OMP stuff you can ditch if you pre-mix.
the other one you don't need anymore, and the OMP stuff you can ditch if you pre-mix.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
