I bought a Bonez cat off another forum member. It didn't come with instructions, which shouldn't be much of a problem. The problem is I'm doing this after work with the store loner tools at my part time job after I close up. Seems like a straight forward job. Anything high and to the right I need to be ready for? It's going to suck if I have to put the old cat back in if I wind up needing something unusual. I bought the bolts and gaskets from rx7.com already. Anything I need to have on hand?

 

only thing you need is the right size tools for the bolts you just purchased. You don't need instruction to install a cat, it's very straight forward...

 

If you have the correct gaskets, you should be set. Only thing you may need is a few feet of heater hose 3/4" heater hose to run to the air inlet from the air pump piping. The stock line is not long enough.

 

Thanks guys. I just like to be prepared. Seems like every time I go to do something it turns into some huge goat rope.