Install apexi neo problem!
#1
Install apexi neo problem!
Hi my car is 1993 fd3s install the apexi neo have check light came out ! The codes is 13 pressure sensor ! Disconnect wire to stock is ok no check light ! why ?
Last edited by Ah Teck; 02-12-14 at 03:25 AM.
#2
I
iTrader: (6)
id suspect either the neo is settings are incorrect ( set for wrong map sensor/ sensor type),
you mixed up the pressure sensor wire, when you spliced into it. (which end goes from neo to ecu, or neo to sensor)
or you just completely cut the wrong wire for the sensor.
was reading a different thread stating u were using a apexi powerfc? is this still installed?
the powerfc would allow much greater adjustments vs the neo, I would only use the pfc.
you mixed up the pressure sensor wire, when you spliced into it. (which end goes from neo to ecu, or neo to sensor)
or you just completely cut the wrong wire for the sensor.
was reading a different thread stating u were using a apexi powerfc? is this still installed?
the powerfc would allow much greater adjustments vs the neo, I would only use the pfc.
#3
thank bro!!
id suspect either the neo is settings are incorrect ( set for wrong map sensor/ sensor type),
you mixed up the pressure sensor wire, when you spliced into it. (which end goes from neo to ecu, or neo to sensor)
or you just completely cut the wrong wire for the sensor.
was reading a different thread stating u were using a apexi powerfc? is this still installed?
the powerfc would allow much greater adjustments vs the neo, I would only use the pfc.
you mixed up the pressure sensor wire, when you spliced into it. (which end goes from neo to ecu, or neo to sensor)
or you just completely cut the wrong wire for the sensor.
was reading a different thread stating u were using a apexi powerfc? is this still installed?
the powerfc would allow much greater adjustments vs the neo, I would only use the pfc.
Thread
Thread Starter
Forum
Replies
Last Post