hi Guys,
i removed the unused wires and checked the other connections too. i found that the black connectors are TYCO and i am still searching for the others (ISC ) .
i need your help again on how to rewrap the harnes. i ordered the DEI silicon tape to use.
when i remove the old wraping i saw that there is
1)a vinil protection first to hold the wires
2)then the vinil is wraped with tape.
3)when the width is increased an extra spiral tube added
Do i need this vinyl beneath the DEI silicon tape and the spiral after the DEI tape??

thanks!!!

 

I didn't use the vinyl or the tubing when I did my harness. I used the DEI tape and some DEI split mesh. I think the factory used the vinyl to reinforce the splits and the tubing to form the harness. Reinforced bends will give your harness a more professional look.

 

I just used some vinyl to initially wrap, then some vulcanizing tape for the outter shell. I didn't bother with any split, spiral or any other kind of tubing. I was thinking of using some aluminium wrap afterwards for a little extra heat protection as well as clean/dress it up a little, but I haven't gotten to that point yet.

 

Can't remember for sure, but I think I got replacement connectors for the injectors from Rotary Experiment Seven. If you need them you can try PM'ing him or contact him through his site http://irperformance.com/