Ok I searched the forum extensively and could never find answers to all my questions that were clear

I am hooking up my Innovate wideband to my pfc and here is how it is hooked up: The red wire on the analog output of the wideband is put into the AN1 on the box, the plain copper one(Ground?) is in the 0V on the box. I have the Innovate programed so that 1.000V=10.00AFR and 5.000V=20.00AFR. First of all is this correct? Second is how do I set up the dataloggit to read the voltage signals and turn them back into AFR's? I can't find anywhere on any of the datalogit's screens to put in a conversion or polinomial. I appreciate any help I can get.

I just dont' seem to get enough views or responses in the PFC forum so thank you for your reply.

 

in the fc edit software, go to set up , then aux, from there you should be able to set it up.
it's also where the polynomial values are input as well.
Tim

 

tks for the reply. I am not so sure that I have the most up to date software, so the first thing I am going to do is to update the FC software and then try going to setup. I swear I didn't see that option when I was looking but I sometimes overlook the obvious in search of the hard way to do things.

Any comments on whether the actual setup and connection is correct?