3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

How do I remove this interior panel?

Thread Tools
 
Search this Thread
 
Old Mar 7, 2002 | 12:12 PM
  #1  
HighRev's Avatar
Thread Starter
Junior Member
Tenured Member 10 Years
 
Joined: Mar 2001
Posts: 29
Likes: 0
From: Tempe, Arizona
How do I remove this interior panel?

I'm trying to uncover the rear driver side speaker and I know you can't just pop the grill off. How do I remove the entire plastic panel in order to expose the speaker?

There's a screw rattling around in there and I need to get it out.
Reply
Old Mar 7, 2002 | 12:17 PM
  #2  
Bucrx7's Avatar
Senior Member
Tenured Member 10 Years
 
Joined: Mar 2001
Posts: 724
Likes: 0
From: Massachusetts
On the non-bose model the grill just pops off.
Reply
Old Mar 7, 2002 | 12:47 PM
  #3  
HighRev's Avatar
Thread Starter
Junior Member
Tenured Member 10 Years
 
Joined: Mar 2001
Posts: 29
Likes: 0
From: Tempe, Arizona
yeah it's the non-bose... someone told me that the entire panel has to be removed. this is not the case?
Reply
Old Mar 7, 2002 | 12:54 PM
  #4  
rx7speed811's Avatar
Accepting Donations.
Tenured Member 10 Years
 
Joined: Mar 2001
Posts: 323
Likes: 0
From: San Francisco, Ca.
just pry that **** out. even on the bose model, you can just pull the little storage bin thingymabob out without taking off the panel. i didnt see any bracket in there where the speaker grill would mount to.
Reply
Old Mar 7, 2002 | 03:13 PM
  #5  
Enthu's Avatar
Still has an RX7.
iTrader: (1)
 
Joined: May 2001
Posts: 1,015
Likes: 5
From: minneapolis MN
down at the very bottom of the piece just behind the seat, there is one screw. remove this screw. then there is a small snap in thing right near it. this must be removed also. then remove the piece that seperates the trunk. there are 2 more small clips on the edge of the piece here that must be pulled out too. now just pry the whole thing off, and be sure if any thing falls off to recover it and replace. this interior piece is mostly snap in stuff.
Reply
Old Mar 7, 2002 | 03:15 PM
  #6  
Enthu's Avatar
Still has an RX7.
iTrader: (1)
 
Joined: May 2001
Posts: 1,015
Likes: 5
From: minneapolis MN
oh wait, before you remove anything, pull the scuff gaurd off (the plastic piece that says "Rx-7". this is a snap on piece too.
Reply




All times are GMT -5. The time now is 01:38 AM.