skim41

Oke,

Here is the catch. My car is finished but doesnt want to start. Its a FD.

I think my timing is off because I didnt do a thing with it, only put the belts on. How do I find top dead center. I have new leads and plugs.
She cranks, has spark and has compression. She even idled for a time but then died. So I adjusted the primary's. for less injection, but no luck.

I have a microtech ECU, checked everything. Running with 850 primary's and 1600 secundaries. Need some help here to finally drive it.

So how do I put it in TDC and can let her Idle.

Thanks
Rogier

Zyon13B

There is no timing with a rotary. everything is handled by the ecu useing the crank sensors on the front. Make sure your not flooding from too much fuel.

rotary

also make sure u have the spark plug wires on the right plugs. also make sure ur getting spark ( this may hurt) after u check that check your fuel lines. intake, compresion, power, exhaust= combustion and running engine.

skim41

Going to have a look and a try again. Maybe too much fuel, anybody got a reference number for a microtech ltx8 with 850cc primaries?

Mahjik

iTrader: (1)

https://www.rx7club.com/microtech-111/

skim41

have tried, with less fuel, started up right away, but only for 1 sec or so. So I'm on the right way.

I have searched, but couldnt find this specific thing.

Mahjik

iTrader: (1)

You need to ask for programming help in the Microtech forum.

skim41

already did but no response yet. Was hoping to find something for tdc instead, thought that was the mistake. Thought also that that couldnt be because of the one way put one pulley.

It idled for 1 sec. this evening, than my battery was flat. put the mixtrim dow a lot. 40 percent less fuel. no wonder because I run 850 primaries'instead of 550