Rear holes are off? Is something out of whack? I can't seem to get the holes to line up.

Thanks

 

Which diff brace is it and how far off are the holes? Mine were a little off so I had to drill them out to make the holes a tad larger so they lined up...

 

I think its a KGParts one. Its about half a inch off.

 

You might whant to check out yor PPF (power plant frame). In this pic it seems that you have a seperation. about the same amount that it is off.

 

Nah my ppf is pretty new and has been cryo'd and reweld'd. Its just the pic.

 

I had problems with a gotham racing one. I just re drilled holes. Hope that helps

 

I enlarged the holes alot to make mine fit. I just bought some new heavy metal cutting blades for my jig saw. A drill press would work best though.

 

Did you guys follow the instructions on how to install it? IIRC, you are supposed to pre-load the differential while installing the brace. Check with KG and have him send you the instructions.

 

There were instructions? I just got a slab of metal when i ordered from KGparts...

 

I got instructions, when you order I got sent a link to a webpage showing installation. I recall its meant to be a 'tight fit', once it was together felt very rigid and does its job very well

 

Yes, I didn't get written instructions either. I did get a link to his company website with a guide on how to properly install it though. Mine didn't line up perfectly as well, I had to preload the brace slightly to get the 12mm bolts in. Hit up Keith: https://www.rx7club.com/members/rxrotary2_7-2463/

 

Thanks for the help guys. I contacted keith