Hardware Spec. For the fastener that holds the slider staybalizer bar on the OEM seat
#1
Hardware Spec. For the fastener that holds the slider staybalizer bar on the OEM seat
For the live of god, I can not figure this out.
The fasteners that hold the seats down are M10 x 1.25, but the damn staybalizer bar (runs parallel to the trams tunnel & fastened by a single bolt, that seems to be integrated into the bar it's self) is a slightly larger fastener.
I've been to a few hardware stores, but I've turned up empty handed (weekend shift kids know about as much about hardware as I do)
Think Mazda might have used a M10.5x1.25 or an M11 (if they even make that size)
I tried various thread pitched M12 fasteners, but it won't thread.
Any help would cure this stroke I'm working on...
The fasteners that hold the seats down are M10 x 1.25, but the damn staybalizer bar (runs parallel to the trams tunnel & fastened by a single bolt, that seems to be integrated into the bar it's self) is a slightly larger fastener.
I've been to a few hardware stores, but I've turned up empty handed (weekend shift kids know about as much about hardware as I do)
Think Mazda might have used a M10.5x1.25 or an M11 (if they even make that size)
I tried various thread pitched M12 fasteners, but it won't thread.
Any help would cure this stroke I'm working on...
Thread
Thread Starter
Forum
Replies
Last Post
need RX7
2nd Generation Specific (1986-1992)
11
08-19-15 08:27 AM